One zone dead and the other ice-cold is a control problem, not a missing condenser. The zoning worth-it page is the buy decision. This page is the repair: you already have two thermostats, dampers in the attic, and a zone board, and the upstairs of a Scripps Ranch or Carmel Valley two-story stopped cooling.

Climate Pros SD matches you with licensed HVAC companies. We do not repair zone dampers or publish prices.

Upstairs bedroom supply vent in a two-story inland San Diego home with the stair opening to the living room below

What usually kills one zone and not the other?

Work down the list. Stop at the first hit.

  1. Wrong mode or setpoint on that zone’s thermostat. Upstairs still in Heat, or a setback so high the board never opens the damper.
  2. Dead batteries or a missing C-wire on the upstairs stat. The downstairs unit still runs. The upstairs damper never gets a call.
  3. Stuck damper. Motor failed, or the blade jammed on a poorly cut takeoff. You hear the system, downstairs vents blow, upstairs is silent.
  4. Bypass or dump zone. Some boards dump extra air into a hallway when both zones call. A mis-set dump can starve the far zone.
  5. Closed manual damper or a booster fan fighting the zone damper. Two products trying to run the same branch.
  6. The outdoor unit is fine, the upstairs coil or a dual-head mini split is not. Confirm you actually have dampers, not two independent systems. A multi-split with one dead head is a mini-split repair, not a zone board.

A booster fan is the wrong first buy here. It does not open a closed damper.

How is this different from “upstairs is always hotter”?

Always hotter with one thermostat is the original zoning sales pitch. One zone that used to work and now does not is a failed part. Inland two-stories still have real attic heat gain. If both dampers open and upstairs is merely warmer, that is load and duct size, not a dead motor.

Mini-split multi-zone is the other San Diego pattern: one outdoor unit, two or three heads, one head not cooling. Frost on that head, a closed isolation valve, or a failed expansion valve are indoor-unit failures. The outdoor unit still serves the other rooms. Tell the matched company which layout you have: dampers in an attic trunk, or wall heads.

What should the site visit include?

Photos of both thermostats, the zone board LEDs, and each damper position with the upstairs calling. Static pressure with one zone open versus both. If they never look at the dampers, they are guessing.

A permit is usually not required for a damper motor swap on existing ducts. New ducts in an attic can trigger City IB-103 ECC/HERS rules when more than 40 feet of new duct is in unconditioned space. The contractor confirms.

Call (442) 777-6440. We match you with a licensed company that will look at the zone board, not only the outdoor unit.