Plenty of San Diego ADUs were built with a wall heater, a window unit, or nothing at all. Now the owner wants real heating and cooling, and the unit is finished. Often a tenant lives there. A mini-split can go in after the fact. The work looks different from a new build. Climate Pros SD matches you with licensed, independent HVAC professionals who do this retrofit work. We don’t publish installed prices.

This guide covers retrofits only. For the new-build basics, start with our ADU mini-split guide.

Why is a retrofit different from a new-build install?

On a new ADU, the HVAC pro works with open framing. Lines get routed before drywall goes up. On a finished unit, every path is a puzzle. Walls are closed. Stucco is painted. Landscaping is in. Someone may be sleeping inside.

A mini-split suits that situation because it needs no ducts. It needs three things:

  • A refrigerant line set between the outdoor and indoor units.
  • A way to drain condensate from the indoor head.
  • A power feed and a communication cable.

Each of those has to find a route through a building that’s already done.

How do the lines get through finished walls?

The pro walks the unit and the exterior first. Then they pick the least damaging route. Here are the usual options.

RouteWhat it looks likeTrade-off to ask about
Straight through the exterior wallShort run, head on an outside wallFewest holes, but the head may land on a wall you don’t want it on
Attic or crawl spaceLines hidden above or belowNeeds access, and the pro must seal the penetrations
Interior closet or chaseLines run inside a cabinet or closetUses storage space, but hides everything
Exterior surface run with a coverLines on the outside, in a color-matched coverQuick, but visible from the yard

Shorter runs mean fewer problems. Place the head where it can cover the room, not just where the lines are easy. Our guide to hiding mini-split lines shows how covers and routing choices look in finished San Diego homes.

Where does the condensate go?

A cooling head makes water. That water has to drain somewhere. In a finished ADU, the pro may use a gravity drain if the path slopes downhill. Where it can’t, a small condensate pump can lift the water to a drain point. Ask the pro where the drain ends. It shouldn’t dump against a foundation or onto a neighbor’s side of the fence. If a head ever drips later, our mini-split dripping water guide covers the causes.

Is there enough electrical capacity?

This is the question that changes the budget. An ADU built with only a wall heater may have a small subpanel, or circuits fed from the main house. The pro checks the manufacturer’s electrical requirements for the model. The electrician then checks what the subpanel and the feed can carry. Sometimes the answer is a new circuit. Sometimes it’s more.

Condenser placement matters here too. Outdoor units have to sit where rules allow. See where you can put an AC condenser. For a panel capacity primer, read the 100-amp panel guide.

Does an existing ADU need a permit for a mini-split?

Ask the pro to confirm, but expect yes. The City of San Diego says mechanical systems can’t be installed, altered, replaced, or repaired without a permit. It offers a Simple “No-Plan” mechanical permit for minor residential installs on properties that aren’t historic. Its examples include installing air conditioner units and forced-air units. Other projects need mechanical plans and calculations. The City points to Information Bulletin 103 to decide which applies.

Two honest limits apply. The City’s page doesn’t name mini-splits. And it says nothing about Energy Code paperwork. So the pro should confirm which permit track your unit gets.

Title 24 enters here too. The California Energy Commission says an alteration is any change to a building’s space-conditioning, water-heating, or lighting system. It lists a newly installed mini-split among alterations the Energy Code covers. Depending on the scope, a mini-split may need field verification and diagnostic testing by an Energy Code Compliance (ECC) rater. The equipment must also meet the mandatory requirements in Section 110.2.

The licensed pro you’re matched with pulls the permit. Climate Pros SD doesn’t.

How do you work around a tenant?

Most of the retrofit happens at the ADU, so plan the access. In California, a landlord may enter a rental to make necessary or agreed repairs, alterations, or improvements. The landlord must give reasonable written notice of the intent to enter. Twenty-four hours is presumed reasonable. Entry has to happen during normal business hours unless the tenant agrees at the time. The landlord can’t abuse that access or use it to harass.

That’s the statute’s baseline, not legal advice. Check your lease and ask your own attorney if anything is unclear.

Here’s how to make the job easier on everyone:

  • Tell the tenant what’s coming and why, before the written notice goes out.
  • Ask the pro for a work window, and share it with the tenant.
  • Ask how many days anyone needs to be in the unit.
  • Cover furniture, and keep the work area clear of belongings.
  • Ask the pro when the power will be off, and for how long.

Say in the notice that the tenant gets heating and cooling out of the work.

What should you ask before you hire?

  1. Which route will the lines take, and where will the walls be opened?
  2. Where does the condensate drain?
  3. Does the subpanel have room, or is a new circuit needed?
  4. Which permit track applies, and who handles inspections?
  5. Will an ECC rater verify the work?
  6. How many days will the tenant need to allow access?

FAQs

Can a window-unit ADU switch to a mini-split without opening walls?

Sometimes. An exterior surface run avoids opening walls. Your pro picks the route after a site visit.

Will the tenant lose power during the install?

If a new circuit goes in, power may be off for a while. Ask the pro when, and warn the tenant.

Who pulls the permit?

The licensed pro you’re matched with does. Climate Pros SD doesn’t pull permits.

Is a mini-split better than a new window unit?

Different tools. Read our mini-split versus window unit comparison for the trade-offs.

Retrofitting an ADU? Call (442) 777-6440. We’ll match you with a licensed local pro who can walk the unit and quote the job.

Related: mini-split installation.