A residential package unit is one outdoor cabinet that holds the compressor, the indoor coil, and the heat (gas heat exchanger or heat-pump reversing valve). Ducts punch through the wall or the roof into that box. There is no attic furnace and no separate condenser. San Diego ranch plans in Clairemont, Kearny Mesa, Mira Mesa, and parts of El Cajon used this layout because there was no attic to hide a split system. It is not a commercial rooftop unit, and it is not a mini split.

Climate Pros SD matches you with licensed HVAC companies. We do not replace package units or publish prices.

A packaged HVAC unit on a concrete pad beside a single-story San Diego ranch house

How is a package unit different from a split system?

A split system has an outdoor condenser and an indoor air handler or furnace, tied by refrigerant lines. A package unit puts both jobs in the yard or on the roof. Service happens at one box. When that box dies, you replace the whole appliance, not “just the condenser.”

A commercial rooftop unit (RTU) is a cousin on a flat roof over a shop or restaurant. That job has curb adapters, disconnects, and after-hours access rules. Use commercial HVAC and the RTU replacement guide for that. This page is the house on a slab with a side-yard package unit.

What fails on San Diego package units?

Coastal salt eats cabinets and coils on units sitting in a side yard in Clairemont or Bay Park. Inland heat runs the compressor hard in El Cajon and Santee. Shared failure modes:

  • Rusted cabinet and seizing outdoor fan
  • Cracked heat exchanger on gas packs
  • Failed compressor or refrigerant leak (the whole charge is in one cabinet)
  • Disconnected or undersized ducts at the wall boot, which feels like a booster fan problem and is usually a leak

Because heat and cool share the box, a “no cool” quote can become a full replacement when the heat exchanger is also condemned. Ask the matched company to say which side failed and whether the other side is worth keeping. Often it is not, on a 15-plus-year pack.

Does a package unit replacement need a City permit?

City of San Diego “What Permits Do I Need” lists Heat Pump Package Unit on the Simple No-Plan MEP HVAC list for single-family homes and duplexes, with furnace, FAU, wall heater, and mini split. Historic sites are excluded. IB-103 also lists heat pump-package unit as a Simple Permit-MEP item. Other cities and the county have their own portals. The matched licensed contractor pulls the permit. See do I need a permit.

Setback from side yards is a zoning issue. City IB-103 notes mechanical equipment in required side or rear yards of Residential Zones must comply with SDMC §131.0461(a)(5). Confirm the pad location with the contractor and the city. This page does not invent a setback in feet.

What should the site visit capture?

Photos of all four sides of the cabinet, the rating plate (tons, gas or heat pump, refrigerant), duct connections at the wall, disconnect and breaker size, and whether a new pad or a roof curb is involved. If you are converting a gas pack to a heat pump pack, ask about electrical capacity and the heat pump service path. Federal 25C does not apply to a 2026 install. Confirm any live SDG&E offer at quote time.

Call (442) 777-6440. We match you with a licensed company that actually works on residential package units, not only split systems.