Emergency Heat on a heat-pump thermostat is a manual switch that runs the indoor electric heat strips and stops the outdoor unit. It is not a secret “more heat” button for a chilly Carlsbad night. Auxiliary heat is different: the thermostat turns strips on by itself when the pump cannot keep up. Mixing those two is how a San Diego bill jumps during a rare cold snap, and how a broken outdoor unit gets ignored.

Climate Pros SD matches you with licensed HVAC companies. We do not set thermostats or publish electric rates.

A hallway thermostat next to a window with an outdoor heat pump condenser visible at night

What is the difference between auxiliary heat and Emergency Heat?

Auxiliary (aux) heat is automatic. On a heat pump with electric strips, the control brings strips on when the outdoor unit is in defrost, when the house is far below setpoint, or when the pump cannot meet the load. You did not press a special mode. The display may say Aux.

Emergency Heat (Em Heat) is a mode you select. The outdoor compressor is locked out. Only the strips heat. You use it when the outdoor unit is dead, iced solid after a failed defrost, or making a noise that means “do not run the compressor,” and you still need heat tonight.

If the house is slowly warming and supply air feels lukewarm, that can be a normal heat pump. Start with heat pump not heating before you touch Em Heat.

When should a San Diego homeowner turn Emergency Heat on?

San Diego winters are mild on the coast. Inland El Cajon, Ramona, and the backcountry get colder nights, and that is where aux strips actually cycle. Em Heat is still for failure, not for “it is 48F outside.”

Turn Em Heat on when:

  • The outdoor unit will not run, and you have already checked the breaker and disconnect
  • The outdoor coil is a solid block of ice after you already tried a thaw-and-retest
  • A tech told you not to run the compressor until a part arrives

Leave Em Heat off when:

  • Air is lukewarm and the house is gaining
  • The outdoor fan is running and the coil is only lightly frosted (defrost is doing its job)
  • You are trying to “speed up” a recovery from 62F after a setback

Strips are electric resistance. SDG&E residential time-of-use plans currently list a 4 p.m. to 9 p.m. on-peak window. Confirm your plan on sdge.com. This page does not publish a cents-per-kWh figure or a monthly bill.

Why does the thermostat keep showing Aux on cold mornings?

That can be normal. Defrost needs heat in the house while the outdoor coil melts. A large morning recovery from a deep setback also calls aux. If Aux stays on for hours on a 55F coastal afternoon, that is a diagnosis: low refrigerant, a failing outdoor fan, a bad outdoor sensor, or strips stuck on. That is a heat pump service call, not a new thermostat.

A missing C-wire can also make a smart thermostat mis-read modes. Fix wiring before you live in Em Heat.

What should you tell the matched company?

Whether you selected Em Heat or it appeared by itself, outdoor temperature, whether the outdoor fan was spinning, ice on the coil, and your thermostat brand. Do not run a screaming compressor “until someone arrives.” After-hours is the matched company’s quote, not a Climate Pros SD promise.

Call (442) 777-6440. We match you with a licensed heat-pump company.